After you configure the Loopback0 interface, which command can you enter to verify the status of the interface and determine whether fast switching is enabled?

After you configure the Loopback0 interface, which command can you enter to verify the status of the interface and determine whether fast switching is enabled?

A. Router#show ip interface loopback 0
B. Router#show run
C. Router#show interface loopback 0
D. Router#show ip interface brief

asked Oct 23, 2016 in 200-120 Cisco Certified Network Associate CCNA by admin (21,060 points)

After you configure the Loopback0 interface, which command can you enter to verify the status of the interface and determine whether fast switching is enabled?

Please log in or register to add a comment.

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.

Related questions